Check 1: Is the power turned on?
- You cannot send faxes if the power is turned off. Press the ON/OFF button to turn the power on.
- If you disconnected the power cord without turning off the power (a mode button is lit), reconnect it, then the power is turned on automatically.
- If you disconnect the power cord after pressing the ON/OFF button to turn off the power (all mode buttons are not lit), reconnect it, then press the ON/OFF button to turn on the power.
- If the power was turned off due to power failure, etc., the power is automatically turned on when the power failure is recovered.
Check 2: Is the document being sent from memory?
When the In Use/Memory lamp is flashing, another document is being sent from memory. Wait until the machine finishes sending it.
Check 3: Is the telephone line connected to the External Device Jack?
Reconnect it to the Telephone Line Jack. Refer to your setup manual.
If you still cannot send a fax, there is a problem with the telephone line. Contact your telephone company and the manufacturer of your terminal adapter or telephone adapter.
Confirming the Telephone Line Connection
For the basic connection of the machine, refer to
Prepare the Machine . This guide describes other typical connections.
The machine cannot send/receive faxes if the connection is incorrect. Connect the machine correctly.
Check 4: Is the telephone line type set correctly?
Check the telephone line type setting and change it as necessary.
Confirming the Telephone Line Connection
For the basic connection of the machine, refer to
Prepare the Machine . This guide describes other typical connections.
The machine cannot send/receive faxes if the connection is incorrect. Connect the machine correctly.
Check 5: Is Hook key setting set to Disable?
When you send a fax manually, dial the number with Hook key setting set to Enable, or dial the number using the telephone connected to the machine.
Check 6: Is Dial tone detect set to ON?
Resend the fax after a while. If you still cannot send the fax, set Dial tone detect to OFF.
Check 7: Is Check RX fax information set to ON?
When Check RX fax information is set to ON, after the machine confirms that the terminal information of the person you want to contact corresponds with the fax number you dialed, the machine will send a fax.
If the machine cannot confirm the terminal information of the person you want to contact, or the fax number you dialed does not correspond with that information, the message "Fax info does not match" is displayed, and the job of sending fax is cancelled.
Check 8: Is the fax number registered correctly for speed dialing?
Make sure that the fax number is registered correctly for speed dialing.
Registering Recipients for Speed Dialing
Speed dialing allows you to dial fax/telephone numbers by simply pressing a few buttons.
The following speed dialing methods are available:
Check 9: Does an error occur during transmission?
Check 10: Is the telephone line connected correctly?
Check that the telephone line is connected correctly to the proper jack. If so, then there is a problem with your telephone line. Contact your telephone company.
Confirming the Telephone Line Connection
For the basic connection of the machine, refer to
Prepare the Machine . This guide describes other typical connections.
The machine cannot send/receive faxes if the connection is incorrect. Connect the machine correctly.
Check 11: Is the document loaded properly?
Remove the document, then reload it on the Platen Glass or in the ADF.
Check 12: Does a printer error occur?
If you are in a hurry, press the Stop button to close the message, then send the fax.