Initial Hardware Setup
15-Des-2011
8201161000
Solusi
To perform setup, place the machine near the access point (wireless LAN) and computer.
Check the included items.
(1) Power cord
(2) FINE Cartridges (Color,Black)
(3) Manuals and other documents
(4) Setup CD-ROM
REFERENCE
Network connection:
- Prepare network devices such as a router or an access point as necessary.
USB connection:
- A USB cable (not included) is required.
Remove the protective sheets and tape.
1. Open the Front Cover and the Paper Output Tray.
2. Open the Paper Output Cover.
3. Remove all the protective tapes and the white fixing material.
Confirm that the protective tapes and the white fixing material are properly removed.
[ Protective tapes and white fixing material ]
4. Close the Paper Output Cover.
5. Connect the power cord.
IMPORTANT
Do not connect the USB cable yet.
6. Adjust the angle of the LCD, then press the ON button.
7. Select your language, then press the OK button.
IMPORTANT
To change the language setting, press the Back button.
8. When screen 1 is displayed, press the OK button.
1. Open the Paper Output Tray and the Paper Output Cover.
(A) Check that the Head Cover has opened automatically.
REFERENCE
If the Head Cover is closed, close the Paper Output Cover, then redo step 1.
2. Lower the Ink Cartridge Lock Lever.
3. Unpack the FINE Cartridge, then remove the protective tape.
Do not touch!IMPORTANT
- Be careful of ink on the protective tape.
4. Insert the FINE Cartridge until it stops.
(A) Insert it straight until it stops.
Do not knock it against the sides!REFERENCE
Install the Color FINE Cartridge to the left and Black to the right.
5. Lift the Ink Cartridge Lock Lever.
Repeat step 2 to 5 to install the other FINE Cartridge.
6. Close the Paper Output Cover.
Wait for about 1 to 2 minutes until screen 2 disappears, then proceed.
IMPORTANT
If an error message appears, check that the FINE Cartridge is installed correctly.
REFERENCE
The LCD turns off if the machine is not operated for about 5 minutes.
To restore the display, press any button on the Operation Panel.
- Setting Plain Paper
1. Check that the Paper Output Tray is closed, then pull out the Paper Support.
2. Slide the right Paper Guide to the end.
The left Paper Guide moves simultaneously with the right guide.
3. Insert paper until it stops.
4. Adjust the Paper Guide to fit the paper size used, then open the Output Tray Extension.
5. Open the Paper Output Tray and the Paper Output Support.
IMPORTANT
- Printing without opening the Paper Output Tray causes an error.
- Loading Photo Paper
Insert paper with the printable side down until it stops. When using photo paper, machine settings for media type and size should be adjusted. For details, refer to the On-screen Manual which will be installed later.
Copy and other functions that do not require a computer are now available.