Images are blurry or not in focus
Solusi
When an image is blurry or cannot be brought into focus during shooting, please check the following.
You can prevent camera shake by holding the camera firmly.
Keep your arms tight against your body while holding the camera firmly by the sides. Be sure that your fingers do not block the <flash>.
When you press the <Shutter Button> halfway in low light conditions where camera shake is likely, a flashing (
) will appear.
) will appear.
)
) a few times to select the [Flash on] (
- Increase the [ISO speed]
Operate the <FUNC./SET> button (
) and <directional button> to set the desired [ISO speed].
) and <directional button> to set the desired [ISO speed].
- Attach the camera to a tripod.
- Press the <Shutter Button> halfway to focus on the subject, then press fully to shoot.
Half-press the <Shutter Button> (press lightly to focus), and then press it fully (without releasing the <Shutter Button>, press it all the way down).
- Shoot the subject within the focusing distance.
- Confirm that functions which you do not intend to use (macro, etc.) are not set.
Press the <Macro> button (
) several times to select a suitable [Focusing Range].
) several times to select a suitable [Focusing Range].
- Shoot using the focus lock or AF lock
- Focus Lock
Change the composition while holding the <Shutter Button> down halfway.
- AF Lock
With the <Shutter button> half-pressed, press (
).
).
The focus locks, and (
) appear on the screen.
) appear on the screen.If you center on the light and dark contrasting area of the subject and push the <Shutter Button> halfway, or repeatedly push the <Shutter Button> halfway, the [AF frame] will appear and the camera will focus.
NOTE
- The camera may not be able to focus in some conditions.
| Focusing zone | ||
|---|---|---|
 )) | ||
 ,  | [Macro] 3 – 60 cm (1.2 in. – 2.0 ft.) (W) |
) to the maximum wide angle side (Max. wide angle).** (T): When turning the toward (
) to the maximum telephoto side (Max. telephoto).