When installing the printer driver, the printer is not recognized automatically even after the USB cable is connected.
Isu
Sebab dan Solusi
The following are probable causes when the printer is not recognized automatically even after you connect the USB cable. Follow the described instructions.
Cause 1:
The USB cable has already been connected and the printer is ON before installing the printer driver.
Remedy:
Turn the printer OFF and disconnect the USB cable. Then, connect the USB cable again and turn the printer ON.
Cause 2:
There is a possibility that the printer is turned OFF.
Remedy:
Turn the printer ON.
Cause 3:
There is a possibility that the USB cable is not connected properly.
Remedy:
Make sure that the printer and computer are connected with the USB cable properly.
Cause 4:
There is a possibility that an inappropriate USB cable is being used.
Remedy:
Make sure that a USB cable appropriate for this printer is being used. The USB interface on this printer is USB 2.0 Hi-Speed (Windows 2000/XP/Server 2003 only) or USB Full-Speed (USB 1.1 equivalent).
Use a USB cable with the following symbol.
Cause 5:
There is a possibility that the printer driver cannot be installed from CD-ROM Setup.
Remedy:
Install the printer driver with Plug and Play. For details on installing the printer driver with Plug and Play, see "Chapter 4 Setting Up the Printing Environment" in User's Guide (PDF manual) in the CD-ROM supplied with the printer.