Shooting subjects up close (PowerShot G7 X)

    16-Sep-2014
    8202188700

    Solusi


      To restrict the focus to subjects at close range, set the camera to [Macro] ().
      IMPORTANT
      • The following section explains the setting procedures when the camera’s shooting mode has been set to [Program AE] ().
      The shooting distance of each [Focusing Range] and the shooting modes in which [Focusing Range] settings cannot be made

      1. Press the <Power> button to turn the camera on.



      2. Press the <> button, choose [Macro] () (either press the <><> buttons or turn the <> dial), and then press the <FUNC./SET> () button.






      3. Once the setting is complete, [Macro] () is displayed.


      REFERENCE
      • If the flash fires, vignetting may occur.
      • To prevent camera shake, try mounting the camera on a tripod and shooting with the camera set to [Self-Timer].
      NOTE
      • The screen indications when operating the <Zoom lever> in [Macro] () mode are as follows.
      In the yellow bar display area below the zoom bar, [ ] will turn gray and the camera will not focus.

      The shooting distance for each [Focusing Range] is as shown in the following table (from the end of the lens). If you shoot beyond the following ranges, the subject may be out of focus.
      Also, the [Focusing Range] cannot be set in some shooting modes. Please see the following table for details.
      Shooting Range Shooting Range When maximum wide angle () is set. When maximum telephoto () is set. is set.
      -5 cm (2.0 in.) – infinity 40 cm (1.3 ft.) – infinity
      Other than the above[Normal] ()5 cm (2.0 in.) – infinity 40 cm (1.3 ft.) – infinity
      [Macro*1]()5 – 50 cm (2.0 in. – 1.6 ft.)-
      [Manual focus*1] ()5 cm (2.0 in.) – infinity 40 cm (1.3 ft.) – infinity
      [Underwater macro *2] ()5 – 50 cm (2.0 in. – 1.6 ft.)-
      [Quick *3] ()1.5 – 20 m (4.9– 66 ft.)1.5 – 20 m (4.9– 66 ft.)
      Shooting modes in which [Focusing Range] cannot be set , , , , , *4, *4, *4, *5, , *6
      *1: Not selectable in some shooting modes.
      *2: In [ ] mode, optical zoom is set to maximum wide angle. Additionally, use of digital zoom may cause images to appear grainy at some resolutions
      *3: In [ ] mode, subjects at close range may not be in focus. In this case, try setting the focus range to [ ].
      *4 : Only selectable in [ ] or [ ].
      *5: Only selectable in [ ], [ ], [ ], or [ ].
      *6 : Only selectable in [ ] or [ ].