Setting RX Reports to Print Automatically (MF4380dn/MF4370dn/MF4350d/MF4340d Only)

    06-Sep-2011
    8200334700

    Solusi


      This section describes how to set RX reports to print automatically.
      The default setting is <OUTPUT NO>.




      The following items are printed in an RX Report:

      • JOB NO.: Job number
      • MODE: Mode of transaction (G3 or ECM)
      • NO.: Sequence number
      • DESTINATION TEL/ID: Number of the sending machine (displayed only if registered in their machine)
      • START TIME: Date and time of transaction
      • PAGE: Number of pages received
      • RESULT: Result of transaction
      - OK: Reception successful
      - NG: Reception failed
      - STOP: Reception manually canceled before completion
      - MEM.FULL: Memory became full during reception.

      1. Press [Menu].

      2. Press [ ] or [ ] to select <REPORT SETTINGS>, then press [OK].

      3. Press [ ] or [ ] to select <RX REPORT>, then press [OK].

      4. Press [ ] or [ ] to select the setting you want, then press [OK].

      • <OUTPUT NO>: Does not print a report.
      • <OUTPUT YES>: Prints a report every time you receive a document.
      • <PRINT ERROR ONLY>: Prints a report only when a reception error occurs.

      5. Press [Stop/Reset] to return to the standby mode.