Blurred or Out of Focus Images (PowerShot SX540 HS)
Solusi
If images are blurred or out of focus when shooting, check the following items.
IMPORTANT
- The instructions in this section apply to a camera with the [Shooting Mode] set to [Program AE] [
].
Hold the camera securely to reduce camera shake.
- Place the strap around your neck.
- When shooting, keep your arms close to your body and hold the camera securely to prevent it from moving. Do not rest your fingers on the [Flash].
In low-light conditions, the [Camera shake warning icon] [ 
] blinks when you press the [Shutter button] halfway. Refer to the following points to prevent camera shake.
] blinks when you press the [Shutter button] halfway. Refer to the following points to prevent camera shake.Set [IS Mode] to [Continuous].
Press the power button.
Press the [MENU] button and then choose the [ 
] tab.
Press the [ 
], [ 
] buttons, choose [IS Settings], and then press the [ 
], [ 
] buttons to set [IS Mode] to [Continuous].
Choose [ 
] (On).
] (On).- Lift the flash, press the [ ] button, and then press the [ ], [ ] buttons to choose [ ] (On).
Increase the ISO speed.
- Press the [ ] button and then press the [ ], [ ] buttons to choose an [ISO Speed].
NOTE
You can set an [ISO Speed] only in the following modes: [ 
], [ 
], [ 
], and [ ].
], [ ], [ ], and [ ].Mount the camera on a tripod or take other measures to keep it still.
- You should set [IS Mode] to [Off] when using a tripod or other means to secure the camera.
Press the [Shutter button] halfway to focus on subjects before pressing it all the way down to shoot.
- Press the [Shutter button] halfway (press lightly to focus) before pressing all the way down (press fully to shoot).
Make sure subjects are within focusing range.
- Shooting Range
| Focus Range | Maximum Wide Angle  | Maximum Telephoto  |
 | 5 cm (2.0 in.) - infinity | 1.3 m (4.3 ft.) - infinity |
 * | 0 - 50 cm (0 in. - 1.6 ft.) | - |
 * | 0 cm (0 in.) - infinity | 1.3 m (4.3 ft.) - infinity |
| * Cannot be selected for some shooting modes. | ||
Set [AF-assist Beam] to [On].
Press the power button. Press the [MENU] button and then choose the [ ] tab. Press the [ ], [ ] buttons to choose [AF-assist Beam], and then choose [On].
Confirm that unneeded functions such as macro are deactivated.
Press the power button. Press the [ ] button, and then choose a [Focus Range] suitable for your environment.
Try shooting with focus lock or AF lock.
[Focus Lock]
As you continue to hold the [Shutter button] halfway down, recompose the shot as desired.
[AF Lock]
- As you continue to hold the [Shutter button] halfway down, press the [ ] button.
- The focus is set and cannot be changed, and [ ] and the MF indicator are displayed.
- Compose the shot and then shoot.
NOTE
- Even if you remove your finger from the shutter button, the focus position is set and cannot be changed.
- As you continue to hold the shutter button halfway down, press the [ ] button once again to cancel.
To have [AF frames] displayed and the camera focus correctly, try composing the shot with higher-contrast subject areas centered and then press the [Shutter button] halfway, or press the shutter button halfway repeatedly.
NOTE
For some shooting scenes and subjects, the camera might not focus correctly.