Setting TX Reports to Print Automatically (MF4380dn/MF4370dn/MF4350d/MF4340d Only)
Solution
This section describes how to set TX reports to print automatically.
The default setting is <PRINT ERROR ONLY>.
The following items are printed in a TX Report:
- JOB NO.: Job number
- MODE: Mode of transaction (G3 or ECM)
- NO.: Sequence number
- DESTINATION TEL/ID: Name and number of recipient
- START TIME: Date and time of transaction
- PAGE: Number of pages sent
- RESULT: Result of transaction
- OK: Transmission successful
- NG: Transmission failed
- STOP: Transmission manually canceled before completion
- NO ANSWER: Call not answered
- PAPER JAM: ADF jam occurs during Manual TX
1. Press 
[Menu].
[Menu].2. Press [ 
] or [ 
] to select <REPORT SETTINGS>, then press [OK].
] or [ ] to select <REPORT SETTINGS>, then press [OK].3. Press [ ] or [ ] to select <TX REPORT>, then press [OK].
] or [ ] to select <TX REPORT>, then press [OK].4. Press [ ] or [ ] to select the setting you want, then press [OK].
] or [ ] to select the setting you want, then press [OK].- <PRINT ERROR ONLY>: Prints a report only when a transmission error occurs.
- <OUTPUT NO>: Does not print a report.
- <OUTPUT YES>: Prints a report every time you send a document.
5. Press 
[Stop/Reset] to return to the standby mode.
[Stop/Reset] to return to the standby mode.