Specifying a portion of an image to save separately (Cropping) (PowerShot SX510 HS / SX170 IS)
22-Aug-2013
8201897500
Solution
The following explains the procedure for specifying a portion of an image to save as a separate image file.
IMPORTANT
- Editing is not possible for images shot at a resolution of [
], or resized to [ ]. - The position and shape of the operation buttons may differ according to the model you use.
1. Press the <
> button to enter Playback mode.
> button to enter Playback mode.2. Press the <MENU> button, and then choose [Cropping] on the [ 
] tab.
] tab.
3. Press the <
><
> buttons to choose an image, and then press the <
> button.
><> buttons to choose an image, and then press the <> button.
4. Adjust the cropping area.
A frame is displayed around the portion of the image to be cropped.
The original image is shown in the upper left, and a preview of the image as cropped is shown in the lower right.
- To resize the frame, move the zoom lever.
- To move the frame, press the <
><
><><> buttons. - To change the frame orientation, press the <DISP.> button.
- Faces detected in the image are enclosed in gray frames in the upper-left image. To crop the image based on this frame, turn the <
> dial to switch to the other frame. - Press the <> button.
5. Press the <><> buttons to choose [OK], and then press the <> button.
><> buttons to choose [OK], and then press the <> button.The image is now saved as a new file.
6. Press the <MENU> button. [Display new image?] is displayed.
Press the <><> buttons to choose [Yes], and then press the <> button.
><> buttons to choose [Yes], and then press the <> button.
The saved image is now displayed.
NOTE
- Images supported for cropping will have the same aspect ratio after cropping.
- Cropped images will have a lower resolution than uncropped images.
This completes the steps for specifying a portion of an image to save as a separate image file.