Inserting and removing batteries and memory cards (PowerShot N100)

    17-Mar-2014
    8202063700

    Solution

    Inserting the Battery Pack and Memory Card
    To insert the included battery pack and a memory card (sold separately), follow these steps.
    REFERENCE
    Note that before using a new memory card (or a memory card formatted in another device), you should format the memory card with this camera.

    1. Open the cover.
    Slide the cover ( ) and open it ( ).



    2. Insert the battery pack.
    While pressing the  battery lock in the direction of the arrow, insert the battery pack as shown and push it in until it clicks into the locked position.
    If you insert the battery facing the wrong way, it cannot be locked into the correct position. Always confirm that the battery is facing the right way and locks when inserted.
    : Terminals



    3. Check the card’s write-protect tab and insert the memory card.
    • Recording is not possible on memory cards with a write-protect tab when the tab is in the locked position. Slide the tab to the unlocked position.
    • Insert the memory card facing as shown until it clicks into the locked position.
    • Make sure the memory card is facing the right way when you insert it. Inserting memory cards facing the wrong way may damage the camera.
    : Terminals



    4. Close the cover.
    Lower the cover ( ) and hold it down as you slide it, until it clicks into the closed position ( ).



    Removing the Battery Pack and Memory Card
    1. Remove the battery pack.
    Open the cover and press the battery lock in the direction of the arrow.
    The battery pack will pop up.



    2. Remove the memory card.
    Push the memory card in until it clicks, and then slowly release it.
    The memory card will pop up.