Inspection Checklist for the Power Cord and Power Plug
Contact the local Canon Service Centres if any of the following problems are found: |
- There are burn marks on the power plug. It is possible that tracking phenomena have started. This is a dangerous condition.
|
| - A power plug prong is deformed.
|
| |
| |
- The power supply goes off and on when the power cord is bent.
|
| - There are cuts, cracks, or indentations on the power cord.
|
| |
| |
- A portion of the power cord becomes hot.
|
|
|
| |
|
|
|
Examples that may cause electric shock or fire and are dangerous: |
- Dust or debris has accumulated on the power supply outlet and power plug.
(Recommendation: Turn the power switch off, disconnect the power plug, and remove dust and debris with a dry cloth.)
|
| - The connector on the device side is loose.
(Recommendation: Push the connector firmly all the way in.)
|
| |
| |
- Stress is being applied to the power cord.
(Recommendation: Position the power cord so that it is not subjected to stress.)
|
|
|
- Disconnecting the plug by pulling on the power cord.
(Recommendation: Always disconnect the power plug by pulling on the plug rather than the cord.)
|
| - Connecting or disconnecting the power plug with wet hands.
(Recommendation: Dry your hands completely with a towel, etc., before connecting or disconnecting the power plug.)
|
| |
| |
- The power plug is loose.
(Recommendation: Push the power plug firmly all the way in.)
|
| - The power cord is tied in a bundle.
(Recommendation: Loosen the power cord.)
|
| |
| |
- The power cord protrudes into a walkway.
(Recommendation: Position the power cord so that it will not obstruct the walkway.)
|
| - The power cord is in front of a heater.
(Recommendation: Position the power cord in a location that is not subjected to heat radiation.)
|
| |
| |
- The product or table tap is at a location near water access.
(Recommendation: Water is the enemy of electricity. Do not use electrical products at a location on which water may come.)
|
| - An excessive number of cords are connected. It is possible that the rated capacity of the table tap has been exceeded.
(Recommendation: Do not connect an excessive number of cords.)
|
| |
| |
